Fluke 6050H User Manual page 11

•
DO NOT overfill the bath. Overflowing extremely hot fluid
may be harmful to the operator. See the Bath Preparation
and Filling section for specific instructions.
•
Follow all safety guidelines listed in the user's manual.
•
Calibration Equipment should only be used by Trained
Personnel.
•
If this equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment
may be impaired.
• Before initial use, or after transport, or after storage in
humid or semi-humid environments, or anytime the
instrument has not been energized for more than 10 days,
the instrument needs to be energized for a "dry-out" period
of 2 hours before it can be assumed to meet all of the safety
requirements of the IEC 1010-1. If the product is wet or has
been in a wet environment, take necessary measures to
remove moisture prior to applying power such as storage in
a low humidity temperature chamber operating at 50 °C for
4 hours or more.
• DO NOT operate high temperature baths (500 °C) near
flammable materials. Extreme temperatures could ignite the
flammable material.
•
Overhead clearance is required. Do not place the instrument
under a cabinet or other structure. Always leave enough
clearance to allow for safe and easy insertion and removal
of probes.
•
The instrument is intended for indoor use only.
•
Ensure that you check the appropriate OSHA and local fire
code regulations for proper equipment required to suppress
a fire for the Salt utilized in the bath.
BURN HAZARD
• High temperatures may be present in this equipment. Fires
and severe burns may result if personnel fail to observe
safety precautions.
• Ensure the bath DOES NOT contain any water and has been
completely dried prior to filling with salt. Any trapped water
can cause a steam explosion resulting in personal injury. If
the bath has recently been filled with water, ensure the
inside of the drain tube is dry prior to filling the bath with
salt.
Calibration Bath
Before You Start
3