Unit Description; Specifications - Shindaiwa BP35 Owner's/Operator's Manual

Unit Description

Using the accompanying illustrations
as a guide, familiarize yourself with this
unit and its various components. Un-
derstanding this unit helps ensure top
performance, long service life, and safer
operation.
WARNING!
Do not make unauthorized modifica-
tions or alterations to this unit or its
components.
IMPORTANT!
BP35 brushcutter units do not have
the spark arrester installed in the muf-
fler. Before placing the brushcutter in
service, check local, state and federal
regulations to determine if a spark
arrester is required in your area. See
page 15 for details.
Specifications
Engine Model ....................................................... SK35F Engine
Dry Weight
(less cutting attachment and guard) .................21.3 lbs./9.7 kg
Type ....................................2-cycle, vertical cylinder, air cooled
Bore x Stroke ........................................................36mm x 33mm
Displacement ................................................... 33.6.cc/2.1 cu. in.
Maximum Power Output ................ 1.8 hp @ 7500 RPM (min
Operating RPM Range ......................... 4,500-7,000 RPM (min
Transmission Type ...................... Automatic centrifugal-clutch
Specifications subject to change without notice
Prior to Assembly
Before assembling this product, please
make sure you have all the components
required for a complete unit:
 Engine Assembly (Powerhead).
 Outer Tube Assembly.
 Cutting Attachment Shield.
 Handle.
Gearcase
Brushcutter
Blade
Figure 3
Fuel/Oil Ratio .............................................. 50:1 with Shindaiwa
Fuel Tank Capacity ..........................................40.6 oz./ 1200 ml
Carburetion ............................................................. TK, float type
Ignition ........................... Fully electronic, transistor controlled
Spark Plug ............................................................. Champion CJ8
) Air Cleaner .............................................................Foam element
-1
) Starting Method ..................................................... Recoil starter
-1
Stopping Method ................................................... Toggle switch
through bevel gears
 Tool bag including: Hex wrenches
and a combination spark plug wrench
and cutting attachment shield mount-
ing hardware.
Carefully inspect all components for
damage.
Fuel
Tank
Cylinder
Cover
BP3503A
Muffler
Outer Tube
Cutting
Attachment
Shield
The terms "left," "left-hand," and "LH":
"right," "right-hand," and "RH"; "front"
and "rear" refer to directions as viewed
by the operator during normal operation
of this product.
Spark Plug
Air Cleaner
Flex
Cable
Throttle
Ignition
Assembly
Switch
Throttle
Trigger
Handle
C35 BRUSHCUTTER
Premium 2-cycle mixing oil
IMPORTANT!
5