Stopping The Engine; Checking Unit Condition - Shindaiwa C242 Owner's/Operator's Manual

Starting the Engine (continued)
When the Engine Starts...
■
After the engine starts, allow the
engine to warm up at idle 2 or 3 min-
utes before operating the unit.
■
If the engine does not continue to
run, repeat the appropriate crank-
ing procedures for a cold or warm
engine.When the engine starts, clear
excess fuel from the combustion
chamber by accelerating the engine
several times with the throttle
trigger.
Starting a flooded engine
1. Slide the ignition switch to the "I" (ON) position.
2. Open the choke, put the throttle trigger in the full throttle position, then clear excess fuel from the combustion chamber by
cranking the engine several times.
3. If the engine still fails to start or fire, refer to the troubleshooting flow chart at the end of this manual.

Stopping the Engine

1. Idle the engine briefly before stop-
ping (about 2 minutes).
2. Slide the ignition switch to the "O"
(Engine OFF) position.

Checking Unit Condition

NEVER operate the unit with the cut-
ting attachment shield or other protec-
tive devices removed!
Use only authorized Shindaiwa parts and
accessories with your Shindaiwa trimmer.
Do not make modifications to this unit
without written approval from Shindaiwa,
Inc.
ALWAYS make sure the cutting attach-
ment is properly installed and firmly
tightened before operation.
NEVER use a cracked or warped cut-
ting attachment: replace it with a ser-
viceable one.
12
■
Advancing the throttle makes the cut-
ting attachment move faster; releas-
ing the throttle permits the attach-
ment to stop moving. If the cutting
attachment continues to move when
the engine returns to idle, carburetor
idle speed should be adjusted (see
"Adjusting Engine Idle".).
ALWAYS make sure the cutting attach-
ment fits properly into the appropriate
attachment holder. If a properly installed
attachment vibrates, replace the attach-
ment with new one and re-check.
ALWAYS stop the engine immediately
and check for damage if you strike a
foreign object or if the unit becomes
tangled. Do not operate with broken or
damaged equipment.
NEVER allow the engine to run at high
RPM without a load. Doing so could
damage the engine.
If the engine does not start
■
Repeat the appropriate starting pro-
cedure for a cold or warm engine.
■
If the engine still fails to start,
use the procedures for "Starting a
flooded engine."
OFF
When the unit is turned off make sure
the cutting attachment has stopped
before the unit is set down.
NEVER operate a unit with worn or
damaged fasteners or attachment
holders.
WARNING!
A cutting attachment shield
or other protective device is no
guarantee of protection against rico-
chet. YOU MUST ALWAYS GUARD
AGAINST FLYING DEBRIS!
IMPORTANT!