Assembly - Shindaiwa BP35 Owner's/Operator's Manual

Assembly: Driveshaft/Powerhead
BP35 Brushcutter
Release Knob
Locking
Hole
"Engine Side"
Throttle Cable
BP3505
Cable Holder
Powerhead
Figure 4
1. Place the powerhead on a flat surface.
2. Route the "engine side" of the flex
cable through the cable holder.
3. Remove the two protective covers
from the flex cable and insert the flex
cable housing marked "engine end"
into the powerhead with the locking
hole facing up. See Figure 4.
4. Lift up on the flex cable release knob
and slide flex cable housing all the
way in until it bottoms in the case and
the release knob locks into the lock-
ing hole in the flex cable housing. See
Figure 5.
Throttle and Handle Assembly
Install the Throttle Cable
Loosen screws
BP3508
Throttle
Lever
Figure 7
1. Loosen the two screws securing the
throttle assembly and slide it forward
on the outer tube. See Figure 7.
2. Remove the cable guide to allow
the throttle trigger to swing out.
See Figure 7.
BP3509
Cable
End
Figure 8
3. Slide the throttle cable through the
hand grip and insert the cable end
into the recess in the throttle trigger.
See Figure 8.
6
7/8"
Label
Figure 5
5. From the opposite end, rotate and
push the drive cable to engage it into
the clutch drum. See Figure 5.
No more than 7/8" (22 mm) of the flex
cable should protrude from the flex cable
housing when properly installed.
BP3510
Cable
Guide
Figure 9
4. Install the cable guide and slide
the throttle assembly back into
place. Tighten the screws securely.
See Figure 9.
BP3511
Throttle Cable
Figure 10
5. Connect the powerhead and stop
switch wire terminals.
BP3506
Figure 6
NOTE:
6. Remove the Phillips head screw
It may be necessary to rotate the
output shaft of the gearcase to fully
engage the drive cable into the lower
tube assembly.
7. Install and tighten the Phillips head
Install the Handle
Cable
Guide
Figure 11
1. Use a Phillips head screwdriver to
2. Position the handle on the outer tube
3. Firmly tighten the (4) handle retain-
Rear Handle O-Ring
Groove
BP3507
Flex Cable
Housing
from the rear hand grip and slide the
O-ring end of the flex cable housing
into the rear of the outer tube handle
until the groove on the housing lines
up with the hole for the Phillips head
screw. See Figure 6.
IMPORTANT!
screw firmly.
Clamp Retaining
Screw
Handle Position
Label
BP3504
Outer Tube
remove the lower clamp retaining
screws from the handle. Separate the
clamp from the handle.
behind the handle positioning label.
Reassemble the lower clamp to the
handle in the reverse order of disas-
sembly. See Figure 11.
ing screws. See Figure 11.
Lower
Clamp