Table of Contents
Advertisement
Assembly
Install the Blade (BP35)
NOTE:
The BP35 is shipped with Holder A, the
safety clip, Holder B, shaft bolt, and bolt
guard installed. The shaft bolt is a LEFT-
HAND THREAD AND IS REMOVED IN A
CLOCKWISE ROTATION!
1. With the gearcase output shaft fac-
ing up, rotate the output shaft and
Holder A until the hole in Holder
A aligns with the matching hole in
the gearcase flange, and then lock
the holder to the gearcase by insert-
ing the long end of the hex wrench
through both holes. See Figure 15.
2. Remove the shaft bolt, bolt guard and
Holder B. See Figure 15.
3. Slide the safety clip off center on the
gearcase shaft. See Figure 15A.
NOTE:
When installing certain blades, it may
be necessary to temporarily remove the
safety clip.
4. Slide the blade over the safety clip
and onto the flange on Holder A.
See Figure 15B.
5. Lock the blade on the shaft by
centering the safety clip.
See Figure 15C.
CAUTION!
Install the blade so the printed
surface is visible to the operator
while the brushcutter is in the normal
operating position.
6. Install Holder B on the gearcase shaft.
See Figure 16.
WARNING!
Never operate the brushcutter
without the safety clip installed and
both holders tightly secured and flat
against the blade surface!
IMPORTANT!
The machined recess in Holder B must
completely surround the safety clip, and
both holders must be flat against the
surface of the blade.
7. Lock Holder A to the gearcase by
inserting the long end of the hex
wrench through both holes as done
in step 1 and tighten the shaft bolt
securely with the combination spark
plug wrench. See Figure 17.
8. Remove the hex wrench.
8
Shaft Bolt
Bolt Guard
Holder B
Safety Clip
Holder A
Hex
Wrench
B
Slip the blade into place
35012
Figure 15
Cutting Blade
Figure 16
Tighten the assembly
Combination Spark
Plug/Screwdriver
Wrench
Holder B
Figure 17
The BP35 should now be completely assembled.
A
35010
Output
Shaft
Slide the safety clip off-center
C
Center the safety clip
35015
Hex Wrench
35011
35013
Install Holder B
35014
Bolt Guard
Advertisement
Table of Contents
