Konica Minolta KM256 Manual page 30

Print head heater mode: Heating for print head, the heating for print head, the light
indicates the current mode under working and shows print head heater temperature
(This mode is reserved mode, the machine is no such mode of heating device, so when the
mode indicator displays the mode, the alarm indicator will light)
Mode button: Press this button once to enter setting mode, setting light will be on, mode
indicator will show a pattern, press the mode button will switch to the next mode. The
temperature indicator displays the set temperature.
Increase the temperature / decrease the temperature: When enter setting mode,
by pressing the two buttons to change the maximum temperature of current mode.
Run button: Enter setting mode, when the setting is finished, click this button to exit the
setting mode. When a certain mode is stopped, enter the setting mode. Press the button to
resume working.
Stop button: Enter setting mode, if you want to stop the heating of a particular mode,
switch to the corresponding mode, press this button to stop the work of the heating mode
and exit setting mode.
Setting case:
(1) Set the temperature at 35 to heat the platform.
(2) Off the heating system
(3) Open the before heating system at the temperature 40, then set the temperature at
℃
1> Mode setting----change the heating mode to the middle platform---press the
up/down button to set the temperature on 35℃--- press the run button to exit the setting
mode
2> Mode setting----change the heating mode to the before platform---press the stop
button to stop the before platform heating and exit the setting mode
3> Mode setting----change the heating mode to the before platform---press the up/down
button to set the temperature on 40℃--- press the run button to exit the setting
mode----press the mode setting to the before heating mode----press the up/down button
to set 45℃--- press the run button to exit the setting mode
Enter the setting mode can only set one heating mode each time, can
not set several heating modes in one time. If you need to set multiple
modes of heating, such as case 3, respectively enter the setting mode
Note！
twice to set
5-2 How to use--printing
Recommended temperatures front heater 40 degrees C; bed heater
38 degrees C; rear heater 45 degrees C. However, if the material is
thick, it should appropriately raise the set temperature
Note！
26