Removing The Appliance Hood - Kärcher CV 66/2 Service Manual

To change a broken height adjustment lever, you must proceed
as described above.
Turn the lever by 90° and pull it out to remove the lever from
the plastic cover
Replace the splint after removing it
Assemble the handle and the adjustment in reverse order of
removal
5.7

Removing the appliance hood

Several disassembly steps are necessary to remove the appli-
ance hood, which are described in more detail in other chapters.
These points are not specifically marked in the text.
Remove operating panel
Removing the handle
Remove the wheel cover. For this, lift the cover using a
screwdriver and carefully release it.
If the locking nose should break off, the cover must be re-
placed.
Unscrew the screw from the wheel shaft
Removing the wheel
Remove the fastening angles on both sides
Tilt the appliance rearward
Remove the brush motor - loosen all 4 screws
Remove the brush motor and pull of the drive belt
7
English