User Interface And Exterior Cabinet Cleaning; Flow Straightener Cleaning/Sanitizing; Chiller/Carbonator Sanitizing Instructions - Follett 7CI100A Installation, Operation And Service Manual

User Interface and Exterior Cabinet Cleaning

1 . Press and release maintenance/clean switch so that only "FRESH FILTERED ICE AND WATER" displays
in the user interface to enter Cleaning Mode (and disable dispensing) .
2 . Plastic parts, including the user interface, can be cleaned with a non-abrasive glass cleaner . Clean
stainless steel panels with stainless steel cleaner .
3 . Press and release maintenance/clean switch to put unit back into service .

Flow Straightener Cleaning/Sanitizing

4 . Remove front panel (see Accessing Internal
Components section) .
5 . Remove the water fitting from the John Guest
fitting .
6 . Remove two screws holding the flow
straightener .
7 .
Soak flow straightener in SafeCLEAN
Plus solution for 15 minutes, rinse, then
reassemble .

Chiller/Carbonator Sanitizing Instructions

Follett offers a chiller/carbonator sanitizing kit (order P/N 01147545) .
1 . Unplug dispenser and turn OFF water supply .
2 . Install dip tube in the filter head .
3 . Mix a 200 ppm active quaternary sanitizing solution of 1 gal . (3 .8 L) 100 F (38 C) water and 1 .6 oz (47 ml)
Nu-Calgon IMS-III Sanitizer (P/N 00979674) .
4 . Fill filter bowl to just below the o-ring with sanitizing solution and screw filter bowl onto filter head .
5 . Remove incoming water supply from Flood Prevention Valve and connect to the IN fitting on filter head .
6 . Remove outgoing water supply from Flood Prevention Valve and connect to the OUT fitting on filter head .
7 . Turn the incoming water ON .
8 . Dispense 12 oz . from Chilled Still Water tap . You should see slight foaming, which ensures sanitizer has
completely filled lines . Discard water collected in container .
9 . Dispense 16 oz . from the Sparkling Water tap . Discard water collected in container .
10 . Allow carbonator pump to cycle .
11 . Dispense an additional 16 oz Sparkling Water . Discard water collected in container .
12 . Allow sanitizer to remain in water lines for at least 5 minutes .
13 . Turn OFF water supply .
14 . Remove filter bowl and filter head from water circuit .
Note: The filter head, filter bowl and dip tube can be cleaned and re-used .
15 . Re-connect Flood Prevention Valve and turn water ON .
16 . Dispense 2 quarts from Chilled Still Water tap .
Note: Foaming will stop when Chilled Still Water line is completely flushed .
17 . Flush the remaining sanitizer through the Sparkling Water tap in no greater than 1 quart increments .
Note: The carbonated sanitizer creates a significant amount of foam .
18 . When Sparkling Water no longer foams, flush an additional 2 quarts sparkling water .
19 . Taste test to ensure there are no off flavors from residual sanitizer . After this procedure any residual
sanitizer will not be at a high enough concentration to have any negative health effects .
22 Sparkling Ice and Water Dispenser 7CI100A/7FS100A, 15CI100A/15FS100A