Table of Contents
Advertisement
8. Rear drain units: Disengage the storage bin drain tube pinch clamp until cleaning solution is drained, then
engage the storage bin drain tube pinch clamp.
9. (UI 12) Fill and drain twice with potable water. Unit can be filled by pressing the Dispense Water button on
the user interface or fill manually through ice bin lid. Return drain tube back into position when complete
Rear drain units: Disengage the storage bin drain tube pinch clamp when complete.
Hot tank units: Disengage the hot tank vent tube pinch clamp when complete.
10. Place a bucket under the dispense chute and remove cap. Caution: Some solution will remain and drain
out when cap is removed.
11. (UI 13) When the Cleaning and Sanitizing procedure is finished, replace cap, lid, right side panel, cover,
chute and drip tray. Press Complete on the user interface.
12. Dispense water for 5 seconds to rinse the dispense tube. (Hot water units: Dispense hot water for 5
seconds.)
Exterior Cabinet
1. To enter Cleaning Screen Mode, press ?.
2. Choose Clean Screen, then Lock.
3. Clean the user interface screen using a damp - not wet - nonabrasive cloth and mild detergent, if
necessary.
4. Press and hold the unlock button to unlock the user interface.
Clean the User Interface Screen
Clean Screen Mode (Dispensing Disabled) - Use when cleaning
surface
Entering Clean Screen Mode disables the User Interface and allows you to
clean the outside of the dispenser without accidentally dispensing ice and/
or water.
1. To enter Cleaning Screen Mode, touch the Follett logo (Fig. 32.1),
then touch
(Fig. 32.2), then touch the Follett logo again
(Fig. 32.3).
2. Choose Maintenance, then Clean Screen, then Lock
3. Clean the user interface screen using a damp - not wet -
nonabrasive cloth and mild detergent if necessary.
4. When done, choose Unlock for approximately 5 seconds and then
press
.
22
Dispenser and Ice Machine - 230 V
Fig. 32
Fig. 33
Advertisement
Table of Contents
