User Interface Display Identifi Cation - Follett 7UC100A Installation, Operation And Service Manual

Service
(continued)

User Interface Display Identifi cation

Operation Display
24 Undercounter Dispenser and Ice machine 7UC100A/7UD100A
––––––––––––––––––––––––––––––––––––––––––––––––––––
PM
Condition
Normal
operation
Cleaning Press and release maintenance/clean switch to
Mode clean the user interface without dispensing ice
or water (see
page 9).
Drip tray full Empty drip tray.
Six-month Follow Maintenance Mode procedure (below)
periodic and also see
maintenance 11.
required
Maintenance Enter Maintenance Mode by pressing
Mode maintenance/clean switch until
Complete the cleaning and sanitizing procedure
shown on
equipped. Exit Maintenance Mode by pressing
and holding maintenance/clean switch until
no longer displays.
Service - 8000 Call Follett Technical Service Group at (877)
hr bushing
612-5086 or +1 (610) 252-7301. The fl ashing
check
wrench indicates that the 8000 hr bushing check
is required.
High amps Contact Follett technical service group at (877)
612-5086 or +1 (610) 252-7301.
Note: For dispensers after serial number
D45191, the phone and wrench will not be
illuminated.
Internal leak in Locate leak and repair - Press reset on control
dispenser board. Contact Follett if ice machine is leaking.
Sleep mode Press either dispense button to return to normal
operation.
Procedure
—
Maintenance/Cleaning Mode on
Cleaning and Sanitizing on page
page 11 and change the fi lter, if so
displays.