Periodic maintenance and adjustment
2. Remove the final gear oil filler bolt
and its gasket, and then check the
oil level in the final gear case.
TIP
The oil level should be at the brim of
the filler hole.
7
1. Final gear oil filler bolt
2. Gasket
3. Correct oil level
3. If the oil is below the brim of the
filler hole, add sufficient oil of the
recommended type to raise it to
the correct level.
4. Check the gasket for damage, and
replace it if necessary.
5. Install the final gear oil filler bolt
and its gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
To change the final gear oil
1. Place an oil pan under the final
gear case to collect the used oil.
2. Remove the final gear oil filler bolt,
the final gear oil drain bolt and
their gasket to drain the oil from
the final gear case.
1
3
2
1
1
1. Final gear oil filler bolt
2. Final gear oil drain bolt
3. Gasket
3. Install the final gear oil drain bolt
and its new gasket, and then tight-
en the bolt to the specified torque.
4. Refill with the recommended final
5. Check the oil filler bolt gasket for
6. Install the oil filler bolt and its gas-
3
2
7. Check the final gear case for oil
7-14
Tightening torque:
Final gear oil drain bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
gear oil to the brim of the filler
hole.
Recommended final gear oil:
SAE 80 API GL-4 Hypoid gear oil
Oil quantity:
0.19 L (0.20 US qt, 0.17 Imp.qt)
damage, and replace it if neces-
sary.
ket, and then tighten the bolt to
the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
leakage. If oil is leaking, check for
the cause.