Short Paper - Brother MFC-L8610CDW User Manual

Error Message
Registration
Supplies
Replace Drum
Replace Toner
Replace WT Box
Scan Unable
Scan Unable ##
Self-Diagnostic
Service Error ##

Short paper

Cause
Registration failed.
It is time to replace the drum
unit.
The drum unit counter was not
reset when a new drum was
installed.
The toner cartridge is at the end
of its life. The machine stops all
print operations.
While memory is available,
faxes are stored in the memory.
It is time to replace the waste
toner box.
The document is too long for
2‑sided scanning.
The machine has a mechanical
problem.
The temperature of the fuser
unit does not rise to a specified
temperature within the specified
time.
The fuser unit is too hot.
Machine's firmware has a
problem.
The length of the paper in the
tray is too short for the machine
to deliver it to the Face down
output tray.
Action
• Press and hold down
machine. Wait a few seconds, and then turn it
on again. Perform the color registration again
using the LCD.
• Install a new belt unit.
• If the problem continues, contact Brother
Customer Service or your local Brother dealer.
Replace the drum unit with a new one.
Reset the drum unit counter.
See the instructions included with the new drum
unit.
Replace the toner cartridge for the color indicated
on the LCD.
Replace the waste toner box with a new one.
Press . For 2-sided scanning, use Letter,
Legal, or Folio size paper. Other paper must be
within the following size:
Length: 5.8 to 14.0 in. (147.3 to 355.6 mm)
Width: 4.1 to 8.5 in. (105 to 215.9 mm)
• Press and hold to turn off the machine,
and then turn it on again.
• If the problem continues, contact Brother
Customer Service.
Contact Brother Customer Service at:
1-877-BROTHER (1-877-276-8437) (in USA)
www.brother.ca/support
or to locate a Brother Authorized Service
Center, visit:
www.brother-usa.com/service
Press and hold to turn off the machine, wait a
few seconds, and then turn it on again. Leave the
machine idle for 15 minutes with the power on.
• Contact Brother Customer Service.
Contact Brother Customer Service at:
1-877-BROTHER (1-877-276-8437) (in USA)
www.brother.ca/support
or to locate a Brother Authorized Service
Center, visit:
www.brother-usa.com/service
Open the back cover (Face up output tray) to let
the printed page exit onto the Face up output tray.
Remove the printed pages, and then press
Retry.
to turn off the
(in Canada)
(in Canada)
562