Removing Compound Rest; Re-Installing Compound Rest - Grizzly G0768 Owner's Manual

Removing
Compound Rest
The compound rest and tool post must be removed
before milling/drilling so the cross slide table can
be used as the milling table.
Tools Needed
Hex Wrench 3mm .............................................. 1
Hex Wrench 4mm .............................................. 1

Removing Compound Rest

Remove the two cap screws that secure com-
pound rest (see Figure 102), then remove it.
Cap Screws
Figure 102. Location of compound rest cap
screws.
Model G0768/G0769 (Mfd. Since 8/15)

Re-installing Compound Rest

Align compound rest with swivel base mounting
holes and nut (see Figure 103), then secure with
cap screws previously removed.
Note: While re-installing compound rest, use a
3mm hex wrench to press swivel base up from
underneath and keep it from sliding back down
into cross slide.
Qty
Figure 103. Swivel base components.
Mounting
Nut
Holes
-61-