Replacing Mill Motor Brushes (G0769) - Grizzly G0768 Owner's Manual

Replacing Mill Motor Brushes (G0769)

1.
DISCONNECT MACHINE FROM POWER!
2.
Remove drawbar cap, then remove motor
cover by removing cap screws (see Figure
154).
Drawbar
Cap
Figure 154. Location of mill motor cover screws.
Model G0768/G0769 (Mfd. Since 8/15)
3.
Cap Screw
(1 of 4)
4.
5.
6.
Unscrew front brush cap and carefully remove
brush from motor (see Figure 155).
Figure 155. Front motor brush components
removed.
Install new brush and re-install brush cap.
Repeat Steps 3–4 to replace rear motor
brush.
Replace mill motor cover and drawbar cap.
Brush
Brush Cap
-87-