Reassembling The Sub Assy Inlet - Brother P-touch QL-710W Service Manual

[6]

Reassembling the Sub ASSY Inlet

(1) Pass the harnesses of the sub ASSY inlet through the hole on the under cover.
(2) Insert the sub ASSY inlet into the hole of the under cover and put it until its hooks
are properly hooked.
Sub ASSY inlet
(3) Solder the harnesses of the sub ASSY inlet to the power supply ASSY as shown
in the figure below.
Harnesses of
the sub ASSY inlet
Hooks
Harnesses of
the sub ASSY inlet
Fig. 3.5-17 Reassembling the Sub ASSY Inlet (1)
Fig. 3.5-18 Reassembling the Sub ASSY Inlet (2)
III - 40
Hole
Power supply ASSY
Harnesses of
the sub ASSY inlet
<Bottom side view>
Under cover