Brother P-touch QL-710W Service Manual page 68

(2) Pass the flat cable of the tape sensor PCB ASSY into the hole on the upper
cover.
(3) Set the insert guide onto the upper cover with the two screws.
Flat cable of the
tape sensor PCB ASSY
Hole
Upper cover
Fig. 3.5-30 Reassembling the Upper Cover and the Under Cover (2)
(4) Turn the upper cover upside down, and then pass the flat cable of the tape
sensor PCB ASSY through the guide of the upper cover.
Flat cable of the tape sensor PCB ASSY
Guide
Fig. 3.5-31 Reassembling the Upper Cover and the Under Cover (3)
Screws
III - 49
Insert guide
Upper cover