Start Wifi Module - Brother P-touch QL-710W Service Manual

1.14 Start WiFi module

Starts the wireless LAN module of the machine from the tool to enter into the WiFi
connection ready state.
(1) Check that the inspection item on the main screen is highlighted in yellow, then
click the [Run] button.
(2) OK/NG selection dialogue appears when the wireless LAN started successfully.
Click [OK] button when the LED above the "WiFi" on the front panel of the machine
lights (or blinks) in green.
→ Click [NG] button to quit the inspection if the LED does not light though the
wireless LAN module has started.
→ If any error occurs at wireless LAN module start-up, the result becomes NG
without showing OK/NG dialogue.
(3) Inspection is completed when "OK" is displayed at the left of the inspection item
field. Check that the WiFi indicator is lit (or blinked) in green. When this inspection
is completed, the next inspection "Check WiFi MAC address" can be performed.
Fig. 48 "Start WiFi module" start-up
Fig. 49 OK/NG dialogue
Fig. 50 "Start wireless LAN module" OK
1 - 30