Condition Setting; Setting The Display Conditions - Konica Minolta CM-700d Instruction Manual

Condition Setting

The CM-700d/600d requires condition settings (display and measurement conditions) before
measurement can be started.
M
emo
To configure condition settings, select "Disp. Cond." (display conditions) or "Meas. Cond." (measurement
conditions) from the <Option> screen to open an appropriate screen.
N
ote
If any predefined condition is selected, the condition setting (display/measurement conditions) is disabled. Set the
condition to OFF before starting condition setting.

Setting the Display Conditions

To set the display conditions, select "Disp. Cond." on the <Option> screen.
You can select or specify the following seven items as the display conditions:
• Disp. Type: Specify items to be displayed as measurement results.
• Color Space: Select the color space to be used.
• Equation: Select the color difference formula to be used.
• Color Index: Select the index (WI, YI, etc.) to be used.
• Observer: Select the observer angle: 2° or 10°
• Illuminant 1: Select the illuminant used to measure colorimetric data.
• Illuminant 2: Select the secondary illuminant used for MI (metamerism index) calculation, etc.
[Setting Procedure]
1
Hold down the [MENU] button and press the
button of the cross key.
The <Option> screen is displayed.
2
Use the or
move the cursor to "Disp. Cond." and then
press the [SAVE/SEL] button.
The <Disp. Cond.> screen is displayed.
N
ote
When setting of "Cond" is "ON" (refer to page E-56),
"Disp. Cond" and "Meas. Cond" cannot be selected.
E-32
button of the cross key to