Lenovo RackSwitch G8332 Command Reference Manual page 243

© Copyright Lenovo 2016
Table 106.
Layer 3 Statistics Commands (continued)
Command Syntax and Usage
show ip policy statistics
Displays statistics for the current routing policy.
Command mode: All
show ip rip counters
Displays Routing Information Protocol (RIP) statistics. See page
sample output.
Command mode: All
show ip route counters
Displays IPv4 route statistics. See page
Command mode: All
show ipv6 route counters
Displays IPv6 route statistics. See page
Command mode: All
show ip slp counters
Displays Service Location Protocol (SLP) statistics.
Command mode: All
show ip tcp counters
Displays Transmission Control Protocol (TCP) statistics. See page
sample output.
Command mode: All
show ip tenant <tenant ID (1‐30)> info
Displays tenant statistics.
Command mode: All
show ip udp counters
Displays User Datagram Protocol (UDP) statistics. See page
output.
Command mode: All
show ip vrrp counters
When virtual routers are configured, you can display the protocol statistics for
Virtual Router Redundancy Protocol (VRRP). See page
Command mode: All
show layer3 counters
Dumps all Layer 3 statistics. Use this command to gather data for tuning and
debugging switch performance. If you want to capture dump data to a file, set
your communication software on your workstation to capture session data
prior to issuing the dump command.
Command mode: All
254 for sample output.
255 for sample output.
262 for sample
278 for sample output.
Chapter 3: Statistics Commands
280 for
260 for
243