Lenovo RackSwitch G8332 Command Reference Manual page 145

Parameter
Filter x profile Indicates the ACL number.
Ethernet
IPv4
TCP/UDP
Meter
© Copyright Lenovo 2016
The following command displays Access Control List (ACL) information:
show access­control list <1‐256>
Command mode: All
Current ACL List information:
­­­­­­­­­­­­­­­­­­­­­­­­
Filter 1 profile:
Ethernet
­ SMAC : 00:00:aa:aa:01:fe/ff:ff:ff:ff:ff:ff
­ DMAC : 00:0d:60:9c:ec:d5/ff:ff:ff:ff:ff:ff
­ VID : 10/0xfff
­ Ethertype : IP (0x0800)
­ Priority : 3
VXLAN
­ VNID : 100
Meter
­ Set to disabled
­ Set committed rate : 64
­ Set max burst size : 32
Re­Mark
­ Set use of TOS precedence to disabled
Packet Format
­ Ethernet format : None
­ Tagging format : Any
­ IP format : None
Actions : Deny
Statistics : enabled
Mirror Target Configuration:
Mirror target destination: port
Egress port for mirror target: 4
If the ACL is being used with Policy‐Based Routing (PBR), the output from this
command is more like the following:
Filter 1 profile: route­map 16
IPv4
­ Protocol : 17
Actions : Permit
: dscp 22
Statistics : enabled
Installed on Port 16
Access Control List (ACL) information includes configuration settings for each
ACL.
Table 65.
ACL List Parameter Descriptions
Description
Displays the ACL Ethernet header parameters, if configured.
Displays the ACL IPv4 header parameters, if configured.
Displays the ACL TCP/UDP header parameters, if configured.
Displays the ACL meter parameters.
Chapter 2: Information Commands
145