Zte ZXV10 W300 Quick Installation Manual page 25

1. Click the Basic Configuration button on the main page, and then
click the Create WAN Connection on the left side of the page to
enter the PPPoE Connection Settings page.
2. Type in the name of the PPPoE connection to be created in the Name
box, e.g. "PPPoE1".
3. Set the NAT and Firewall options to default (enable).
4. If you select VLAN from Sharing, please configure VLAN ID and
Priority according to the parameter description.
5. Input parameters in the PPP settings area. Please contact your
service provider for the specific values.
6. Input the VPI and VCI values in the PVC settings area. Please
contact your service provider for the specific values.
7. Select an option from QoS. If you are not sure of the setting or your
service provider cannot provide you the required information, use the
default.
8. Click Submit to complete the PPPoE connection configuration.
After the new connection is created, the connection name is
displayed on the left side of the page. You can use the Connect,
Disconnect, Submit and Delete buttons to manage this
connection.
9. Click the Save button on the page.
10. Click the Status button on the main page, and then the Connection
Status button on the left side of the page.
Chapter 4 Wizard
25