Zte ZXV10 W300 Quick Installation Manual page 15

automatically is checked.
6) Click OK twice to confirm and save your settings.
2. Configure the PC to use a static address:
1) From the Windows taskbar, select Start > Control
Panel.
2) Double-click the Network Connection icon.
3) From the right-button menu, select Local Area
Connection > Properties. Select Internet Protocol
(TCP/IP) > Properties.
4) In the Internet Protocol (TCP/IP) Properties
dialog box, click Use the following IP address to specify
the local computer's IP address to the same network
segment as the LAN port address of the device, i.e.
192.168.1.x (in which the "x" is a decimal integer between
2~254). For
255.255.255.0. The Default Gateway is set to 192.168.1.1.
5) Configure
addresses. To set the DNS server IP addresses, please
contact your local Service Provider, or set it to 192.168.1.1.
6) Click OK twice to confirm and save your settings.
3. After completing the above configuration:
1) If the device is set to the bridging mode, you can
access the Internet using the service (e.g. PPPoE dial-up)
provided by the your service provider.
2) If the device is set to the routing mode, you can
access the Internet directly when it has been connected to
the office-end device successfully.
3) To check the ZXV10 W300 device settings, visit
http://192.168.1.1 via a browser and log on to the device
using admin as both the username and the password.
Chapter 3 Quick Installation
example, 192.168.1.2,
Use the following
subnet mask
DNS server
15