Advertisement
Main Menu
HomeLink Universal Transceiver
1.
Unplug the garage door opener
motor from the house current.
2.
Hold the end of the garage door
opener remote control 2 to 5
inches from HomeLink. Make
sure you are not blocking your
view of the red light in HomeLink.
154
Comfort and Convenience Features
Table of Contents
3.
Press and hold the remote control
button and one of the HomeLink
buttons at the same time.
The remote control
Canadian Owners:
you are training from may stop
transmitting after two seconds. This
is not long enough for HomeLink to
learn the code. Release and press the
button on the remote control every
two seconds until HomeLink has
learned the code.
4.
The red light in HomeLink should
begin flashing. It will flash slowly
at first, then rapidly.
5.
When the red light flashes rapidly,
release both buttons. HomeLink
should have learned the code from
the remote control.
6.
Plug in the garage door opener
motor, then test the HomeLink
transceiver button by pushing it. If
the button does not work, repeat
the procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink transceiver button you
just trained. If the red light blinks
for 2 seconds then stays on, you
have a rolling code garage door
opener. Go to ''Training with a
Rolling Code System'' (see page
155
).
7.
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
Advertisement
