Advertisement
Main Menu
The HomeLink Universal
Transceiver built into your vehicle
can be programmed to operate up to
three remotely controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
General Information
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor for that
device during training. Pepeatedly
pressing the remote control button
could burn out the motor.
The HomeLink transceiver stores
the code in a permanent memory.
There should be no need to retrain
HomeLink if your vehicle's battery
goes dead or is disconnected. If your
garage door opener was
manufactured before April 1982, you
may not be able to program
HomeLink to operate it. They do not
have the safety feature that causes
Table of Contents
the motor to stop and reverse if an
obstacle is detected during closing,
increasing the risk of injury.
Important Safety Precautions
Always refer to the opening
instructions and safety information
that came with your garage door
opener or other equipment you
intend to operate with the HomeLink
Universal Transceiver. If you do not
have this information, contact the
manufacturer of the equipment.
HomeLink Universal Transceiver
Training HomeLink
Before you begin
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first button.
To do this, press and hold the two
outside buttons on the HomeLink
transceiver for about 20 seconds,
until the red light flashes. Release
the buttons, then proceed to Step 1.
If you are training the second or
third buttons, go directly to Step 1.
Comfort and Convenience Features
If you just
−
CONTINUED
153
Advertisement
