The relationship between the orientation in which you place the original and the punch hole
positions is as follows:
In the following illustration, two holes is specified, however the punch hole positions are the same
regardless of the number of holes.
*1 The above table shows punch hole positioning. Punched sheets might not be delivered in the orientation
shown in this table.
*2 If you want to punch holes in this position, select unreadable orientation in Original Orientation, and
then select the punch hole position.
*3 You cannot punch holes in this position when copying onto B4 JIS, 8 × 13 or larger, or 5
1.
Press [Finishing].
2.
Select one of the punch hole positions.
When the internal finisher is attached:
*1
*3
*2
*2 *3
CHF033
Finishing
2
1
1
/
× 8
/
.
2
2
89