Omron NB3Q-TW00B Startup Manual Manual page 96

6 Maintenance and Troubleshooting
7
When opening a project, what if there is a prompt: [Font not existing in the system]
For example: if attempting to open a project involving
, a prompt "[SimHei] does not exist" will pop up, as follows:
If this font issue is ignored,
UnBatang.
8
How to set the addresses of the component for displaying Alarm and Event, and how to inquire
Alarm and Event
It's best to use the internal register of the PT - LW for the address type of the component for
displaying Alarm and Event, and the address can be designated as any of the vacant address
in the project. When we record Alarm and Event on PT, one page is almost certainly not
enough, then turn-page inquiring is needed to be set, thus the address in the properties of the
component for displaying Alarm and Event takes effect. Take LW10 for an example, as follows:
6-8
will be replaced with a font that exists in the system, eg.
NB-series Programmable Terminals Startup Guide Manual(V109)
in a PC that does not incorporate