Omron NB3Q-TW00B Startup Manual Manual page 74

4 Screen Creation
The whole screen is shown below. The creating methods for fixed text and Bit Button components for
[Open], [Stop] and [Close] garage door operations are the same as that of [1 Wait].
a
b
d
a Screen b Fixed Texts c Bit Lamp d Function Keys e Bit Button components
Bit Lamp Components
The states of the vehicle sensor, light sensor, upper LS and lower LS are shown by the lamp.
The property settings for the Bit Lamp are:
Corresponding
Name
Read Address
Type
Label
Graphics
Function Key Components
These are used for switching to [1 Wait] and [7 Check 2] screens.
The property settings of the Function Key components are:
Screen Name
Function Key
Label
Graphics
[7 Check 2]
The [7 Check 2] screen will appear after the screen-switching button on [6 Check 1] or
[8 Check 3] screen is pressed.
Configure functions below:
• Fixed text indicating the garage door state.
• Bit Lamp components activating relevant lamp to check operations when the [OPEN], [STOP] or
[CLOSE] Function Key turns ON.
• Function Key component, a button for switching to [6 Check 1] and [8 Check 3] screens.
• Bit Button components, allocated to [Open], [Stop] and [Close] garage door operations respectively.
4-22
c
Vehicle Sensor Light Sensor
CIO_bit0.03 CIO_bit0.04
Normal
Do not use
Use the vector graphic: Lamp2State1-00.vg
Wait Screen
Change screen [1 Wait]
Transport font:
0: Wait Screen
1: Wait Screen
Use the vector graphic: CTRL_BAR001.vg
Upper LS
CIO_bit0.05
Change screen [7 Check 2]
Transport font:
0: Next Screen
1: Next Screen
NB-series Programmable Terminals Startup Guide Manual(V109)
e
Lower LS
CIO_bit0.06
Next Screen