Omron NB3Q-TW00B Startup Manual Manual page 47

Mounting NB Unit to Control Panel
Install the NB Unit by embedding it into the operation panel.
Use the panel mounting brackets and Phillips screwdriver installation.
Proceed the installation following the procedures below.
1
Panel cutout with dimensions is shown below. Fit the NB Unit into the panel from the front side.
Opening dimensions
NB3Q-TW00B/TW01B
NB5Q-TW00B/TW01B
NB7W-TW00B/TW01B
NB10W-TW01B
2
As follows, insert the panel mounting brackets at the locations indicated by red box around the
back of the NB Unit. Insert the hooks of positioners into the square holes on the Unit to hold the
fixators properly, and tighten the screws firmly with the screwdriver.
NB5Q/NB7W-TW
NB-series Programmable Terminals Startup Guide Manual(V109)
Width
Height
Models Opening Dimension (W H mm)
119.0(+0.5/-0) 93.0(+0.5/-0)
172.4(+0.5/-0) 131.0(+0.5/-0)
191.0(+0.5/-0) 137.0(+0.5/-0)
258.0(+0.5/-0) 200.0(+0.5/-0)
B
3 Installation and Wiring
3
3-3