Reset Menu; Set Ip Address - Brother HL-1850 Service Manual
Hide thumbs
Also See for HL-1850:
- Service manual (303 pages) ,
- Quick setup manual (2 pages) ,
- Guide d'installation rapide (2 pages)
Table of Contents
Advertisement
CHAPTER 2 INSTALLATION AND BASIC OPERATION
5.5.8
Reset menu
Setting Menu
RESET PRINTER
FACTORY RESET
5.5.9
Set IP address
INFORMATION
NETWORK
TCP/IP
TCP/IP ENABLE
IP ADDRESS=
192.0.0.192
123.0.0.192
123.45.67.89
123.45.67.89
Description
Resets the printer and restores all printer settings – including
command settings – to settings you have previously made with
the control panel switches.
Resets the printer and restores all printer settings – including
command settings – to the factory settings. See
5.5.11 ‘List of factory settings’ in this
Press the + or – switch to select the “NETWORK” menu.
Press the Set switch.
Press the Set switch.
Press the + switch.
Press the Set switch.
The last number in the digit which you can change is blinking.
Press the + or – switch to increase or decrease the number.
Press the Set switch to go to next digit.
Repeat this until you have set your IP address.
Press the Set switch to complete the IP address.
An asterisk appears at the end of the display.
2-38
subsection
Chapter.
Advertisement
Table of Contents
Troubleshooting
