Brother HL-1850 Service Manual page 113

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
NOTE:
When replacing/re-assembling the pad holder ZLh ASSY, remove the old grease and apply a
suitable amount of grease referring to the figure below;
Grease: Molykote PG-662
(1 rice-grain size)
(3) Turn the paper cassette upside down, then remove the tray cover film by peeling it
carefully from the underside of the cassette.
(4) Remove the TORX pan B M3x8 Taptite screw and remove the paper tray cover from the
front of the cassette.
NOTE:
• The cover film must not be reused after it has been removed. Always replace it with a new
one.
• The screw securing the paper cassette cover indicated RED in the figure above is very
special. When disassembling/re-assembling the screw, you need a special screw driver.
Refer to the parts reference list.
Tray cover film
Paper pick-up roller
Fig. 4-5
Taptite, TORX pan B M3x8
Paper cassette
Paper tray cover
Fig. 4-6
4-6
Paper cassette