Communication condition of Bluetooth interface
: Supported by Ver. 3.2.0 or later.
Functions
Receive buffer capacity
4KB (initial setting)
45 bytes
BUSY condition
Receive buffer full/Offline (initial setting)
Receive buffer full
Auto line feed
Normally disabled (initial setting)
Normally enabled
USB power-saving function
Disabled
Enabled (initial setting)
Release condition of receive buffer BUSY
Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting)
Releases when the remaining receive buffer capacity becomes 138 bytes
44
Item\Method
For information about how to use the software setting mode, see
57.
The receive buffer capacity for the Bluetooth interface is 64 K bytes.
In either case above, the printer enters the BUSY state after power is turned on, and when a self-
test is being run.
This function is enabled only when Receive buffer capacity is set to 4KB.
The USB power-saving function is valid only when the USB interface communication condition is
set to the vendor-defined class and the system configuration is set so that the USB driver can sup-
port the USB power-saving function.
TM Utility for iOS,
TM-m30 Utility
for Android
for Windows
✔
✔
"Software Setting Mode" on page
Software
Setting Mode