Before You Begin; The Broadband Screen - ZyXEL Communications VMG3312-T20A User Manual

6.1.3 Before You Begin

You need to know your Internet access settings such as encapsulation and WAN IP address. Get this
information from your ISP.

6.2 The Broadband Screen

Use this screen to change your VMG's Internet access settings. Click Network Setting > Broadband from
the menu. The summary table shows you the configured WAN services (connections) on the VMG.
Figure 27 Network Setting > Broadband
The following table describes the labels in this screen.
Table 10 Network Setting > Broadband
LABEL
Add New WAN
Interface
#
Name
Type
Mode
Encapsulation
802.1p
802.1q
Igmp Proxy
NAT
Default
Gateway
IPv6
MLD Proxy
Modify
Chapter 6 Broadband
DESCRIPTION
Click this button to create a new connection.
This is the index number of the entry.
This is the service name of the connection.
This shows whether it is an ATM, a PTM or an Ethernet connection.
This shows whether the connection is in routing or bridge mode.
This is the method of encapsulation used by this connection.
This indicates the 802.1p priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
This indicates the VLAN ID number assigned to traffic sent through this connection. This displays
N/A when there is no VLAN ID number assigned.
This shows whether the VMG act as an IGMP proxy on this connection.
This shows whether NAT is activated or not for this connection.
This shows whether the VMG use the WAN interface of this connection as the system default
gateway.
This shows whether IPv6 is activated or not for this connection. IPv6 is not available when the
connection uses the bridging service.
This shows whether Multicast Listener Discovery (MLD) is activated or not for this connection. MLD
is not available when the connection uses the bridging service.
Click the Edit icon to configure the WAN connection.
Click the Delete icon to remove the WAN connection.
VMG3312-T20A User's Guide
74