ZyXEL Communications VMG3312-T20A User Manual page 106

Note: The VMG applies the security settings of the SSID1 profile (see
you want to use the WPS feature, make sure you have set the security mode of SSID1 to
WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click Apply to
activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 42 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 25 Network Setting > Wireless > WPS
LABEL DESCRIPTION
General
WPS Select Enable to activate WPS on this VMG.
Add a new device with WPS Method
Method 1 Use this section to set up a WPS wireless network using Push Button Configuration (PBC). Select
Enable and click Apply to activate WPS method 1 on the VMG.
WPS Click this button to add another WPS-enabled wireless device (within wireless range of the
VMG) to your wireless network. This button may either be a physical button on the outside of
device, or a menu button similar to the WPS button on this screen.
Note: You must press the other wireless device's WPS button within two minutes of
Method 2 Use this section to set up a WPS wireless network by entering the PIN of the client into the VMG.
Select Enable and click Apply to activate WPS method 2 on the VMG.
Register Enter the PIN of the device that you are setting up a WPS connection with and click Register to
authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device's settings.
Note: You must also activate WPS on that device within two minutes to have it
Method 3 Use this section to set up a WPS wireless network by entering the PIN of the VMG into the client.
Select Enable and click Apply to activate WPS method 3 on the VMG.
Chapter 7 Wireless
pressing this button.
present its PIN to the VMG.
VMG3312-T20A User's Guide
106
Section 7.2 on page 97). If