5 ] Installing The Dc Motor Assy And The Motor Holder - Brother PT-1090 Service Manual

[ 5 ] Installing the DC Motor ASSY and the Motor Holder

(1) Turn the bottom cover upside down.
(2) Set the DC motor ASSY to the motor holder with the two screws.
(3) Set the motor holder to the bottom cover with the two screws.
NOTE: When installing the motor holder, check that it is 20.22mm ±0.05 between
the shaft of the motor holder and the shaft "A" of the bottom cover.
(4) Pass the two motor leads through the guide groove "a", and pass the black motor
lead through the guide groove "b", and pass the red motor lead through the guide
groove "c".
Shaft of motor holder
Shaft "A"
"a"
"b"
Motor lead (red)
Figure 3.1-24 Installing the DC Motor ASSY and the Motor Holder
Screws
20.22 0.05
Motor lead (Black)
"c"
III - 24
Screws
Motor holder
DC motor
Bottom cover