2 ] Removing The Cutter Case Assy And Board - Brother PT-1090 Service Manual

[ 2 ] Removing the Cutter Case ASSY and Board, and Separating the Bottom Cover
and the Upper Cover
(1) Pull out the cutter case ASSY and board.
(2) Remove the seven screws from the bottom cover.
(3) Discharge the capacitor mounted on the main PCB by touching both the + and -
terminals (of the main PCB ASSY) with a tweezers.
Board
Cutter case ASSY
Screws
Upper cover
Bottom cover
Figure 3.1-4 Removing the Cutter Case ASSY and Board
Screws
+ terminal
(of the main
PCB ASSY)
III - 4
Discharging the capacitor
on the main PCB ASSY
Tweezers
- terminal
(of the main
PCB ASSY)