Default Ip Gateway Configuration - HP ProLiant BL p-Class GbE2 Command Reference Manual

The Configuration Menu

Default IP Gateway Configuration

Command: /cfg/ip/gw <gateway number>
[Default gateway 1 Menu]
The GbE2 Interconnect Switch supports two gateways. By default, no gateways are
configured on the switch. Type 1 or 2 in the command as the <gateway number>, depending
upon which gateway you want to configure.
The following table describes the Default IP Gateway Configuration Menu options.
Table 6-12: Default IP Gateway Configuration Menu Options
Command
addr <default gateway address (such
as, 192.4.17.44)>
intr <0-60 seconds>
retry <number of attempts>
arp disable|enable
ena
dis
del
cur
6-16
HP CONFIDENTIAL Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:57 PM
addr - Set IP address
intr - Set interval between ping attempts
retry - Set number of failed attempts to declare gateway DOWN
arp - Enable/disable ARP only health checks
ena - Enable default gateway
dis - Disable default gateway
del - Delete default gateway
cur - Display current default gateway configuration
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
Description
Configures the IP address of the default IP
gateway using dotted decimal notation.
The GbE2 Interconnect Switch pings the default
gateway to verify that it is up. The intr option
sets the time between health checks. The range
is from 1 to 120 seconds. The default is 2
seconds.
Sets the number of failed health check attempts
required before declaring this default gateway
inoperative. The range is from 1 to 120
attempts. The default is 8 attempts.
Enables or disables Address Resolution
Protocol (ARP) health checks. This command is
disabled by default.
Enables the gateway for use.
Disables the gateway.
Deletes the gateway from the configuration.
Displays the current gateway settings.