Setup Part 3: Vlans - HP ProLiant BL p-Class GbE2 Command Reference Manual

First-Time Configuration
3. Configure Gigabit Ethernet port auto-negotiation mode.
The system prompts:
Port Auto-negotiation:
Current Port 1 auto-negotiation:
Enter new value ["on"/"off"]:
Enter on or off. Press the Enter key to keep the current setting.
4. If configuring VLANs, enable or disable VLAN tagging for the port.
If you selected to configure VLANs in Part 1, the system prompts:
Port VLAN tagging config (tagged port can be a member of multiple
VLANs)
Current TAG flag:
Enter new TAG status [d/e]:
Enter d to disable VLAN tagging for the port or enter e to enable VLAN tagging for the
port. To keep the current setting, press the Enter key.
5. The system prompts you to configure the next port:
Enter port number:
When you are finished configuring ports, press the Enter key without specifying any
port. Otherwise, repeat the steps in this section.

Setup Part 3: VLANs

If you selected to skip VLAN configuration in Part 1, skip to the "Setup Part 4: Internet
Protocol Configuration" section.
1. Enter the number of the VLAN to configure, or press the Enter key to skip VLAN
configuration at the prompt:
VLAN Config:
Enter VLAN number from 2 to 4095, NULL at end:
If you wish to change settings for individual VLANs, enter the number of the VLAN you
wish to configure. "NULL at end" means to skip VLAN configuration, press the Enter
key without typing a VLAN number. If you skip VLAN configuration, go to the "Setup
Part 4: Internet Protocol Configuration" section.
2. Enter the new VLAN name at the prompt:
Current VLAN name:
Pending new VLAN name: VLAN 2
Enter new VLAN name:
3-6
HP CONFIDENTIAL Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:50 PM
disabled
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
on