System Configuration - HP ProLiant BL p-Class GbE2 Command Reference Manual

The Configuration Menu
For instructions on selecting the configuration to run at the next system reset, refer to the
"Selecting a Configuration Block" section in Chapter 8.

System Configuration

Command: /cfg/sys
[System Menu]
This menu provides configuration of GbE2 Interconnect Switch management parameters such
as user and administrator privilege mode passwords, browser-based management settings,
and management access list.
The following table describes the System Configuration Menu options.
Table 6-2: System Configuration Menu Options
Command
syslog
sshd
radius
ntp
date
time
idle <idle timeout in minutes;
affects both console and Telnet>
6-4
HP CONFIDENTIAL Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:57 PM
syslog - Syslog Menu
sshd - SSH Server Menu
radius - RADIUS Authentication Menu
ntp - NTP Server Menu
date - Set system date
time - Set system time
idle - Set timeout for idle CLI sessions
snmp - Set SNMP access control
wport - Set Web server port number
notice - Set login notice
bannr - Set login banner
mnet - Set management network
mmask - Set management netmask
tnet - Enable/disable Telnet access
tnport - Set Telnet server port number
hprompt - Enable/disable display hostname (sysName) in CLI prompt
bootp - Enable/disable use of BOOTP
http - Enable/disable HTTP (Web) access
user - User Access Control Menu (passwords)
tport - Set the TFTP port for the system
cur - Display current system-wide parameters
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
Usage
Displays the Syslog Menu.
Displays the SSH Server Menu.
Displays the RADIUS Authentication Menu.
Displays the Network Time Protocol (NTP)
Server Menu.
Prompts the user for the system date.
Configures the system time using a 24-hour
clock format.
Sets the idle timeout for CLI sessions, from 1 to
60 minutes. The default is 5 minutes.
continued