Superior TF18NV Installation And Operation Instructions Manual page 28

Unvented (vent-free) gas log heater
Table of Contents

Advertisement

FLAME HEIGHT
This function allows you to control height of
fl ames through 5 levels
lect manual fl ame height function by pressing
MODE button until a fl ame is shown in lower
left corner of display. Use UP/DOWN arrow
button to set desired fl ame height (see Figure
56, Page 27). A beep from receiver confi rms
the command.
ON
MINIMUM
Figure 57 - Remote Control Display of
Flame Height Minimum and Maximum
ROOM THERMOSTAT
The remote control can operate as a room
thermostat. The thermostat can be set to a
desired temperature to control the comfort
level in the room.
To activate, press THERMOSTAT button on
remote control (see Figure 56, Page 27). The
word ON will appear to the right of temperature
bulb graphic on display (see Figure 58). Use
UP/DOWN arrow button to set desired room
temperature. Control system will cycle fi replace
on or off to maintain selected temperature.
ON
Figure 58 - Room Temperature Setting
SMART THERMOSTAT
The Smart Thermostat adjusts fl ame height
in accordance to differences between set
temperature and room temperature. As room
temperature gets closer to set temperature the
smart function will modulate the fl ame lower.
As room temperature cools, it will modulate
the fl ame higher.
28
OPERATION
Continued
(see Figure
57). Se-
ON
MAX
MAXIMUM
Room
Temperature
Set
Temperature
SuperiorFireplaces.us.com
To activate this function, press THERMOSTAT
button until the word SMART appears to the
right of temperature bulb graphic on display.
Use UP/DOWN arrow button to set desired
room temperature. The control system will
cycle the fi replace on or off to maintain se-
lected temperature.
SMART
MAX
Figure 59 - Smart Thermostat Setting
CHILD SAFETY LOCK-OUT
This function lets you deactivate the remote
control buttons. It is active when the lock icon
is lit on the display.
To activate, press MODE button and UP ar-
row button at the same time. To deactivate,
press again.
ON
Figure 60 - Child Safety Lock-Out
REPLACING HAND-HELD REMOTE
CONTROL ONLY
If your remote ever needs to be replaced you
will not need to replace the receiver.
To program receiver with a new hand-held
remote, insert a small pin or paper clip into
hole on receiver face plate marked PRG.
The receiver will beep 3 times to indicate it
is ready to accept a new remote transmitter.
Press the ON/OFF button on your remote
and the receiver will beep 4 times to confi rm
it receives commands from the new remote.
ON REMOTE OFF
Figure 61 - Programing Remote Control
to Receiver
PRG
To
Program
Receiver
126817-01D

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tf18pvTf2430nvTf2430pv

Table of Contents