Superior TF18NV Installation And Operation Instructions Manual page 24

EMBER PLACEMENT
WARNING: Do not use any other
ember material not supplied with
this unit.
WARNING: Do not operate unit
without ember material correctly in
place as shown in Figures 49 and
50. Do NOT place ember material
anywhere else on the unit. Use only
ember material supplied with unit.
Excessive or incorrectly placed
ember material may produce carbon
monoxide or soot. If replacement
embers are needed, the replacement
embers must be purchased from
IHP. See Page 38 for part numbers.
WARNING: All previously ap-
plied loose material must be re-
moved prior to reapplication.
Ember Material
Glowing Embers
Figure 50 - Placement of Glowing Embers (shown with Platinum Bright Embers)
24
INSTALLATION
Continued
1. Two ember materials are supplied with
2. Add Volcanic Stone and small decorative
Figure 49 - Platinum Bright Embers
SuperiorFireplaces.us.com
this log set. Platinum Bright Embers give
a bright glow appearing as hot coals.
Should embers need replacing, see Parts,
Page 37.
Platinum Bright Ember placement. Add
embers to front, fl at burner. Gently remove
embers from bag. Separate pieces of
ember material and place on surface of
fl at burner just behind horizontal ports as
shown in Figure 49.
Glowing Embers placement. Place
Glowing Ember material on front flat
burner in areas away from ports as shown
in Figure 50.
logs around base of appliance if desired.
DO NOT place rock or additional logs
on front burner or on logs. Placing any
material on unit other than ember material
on front burner may result in production
of carbon monoxide or soot. Use Volca-
nic Stone to hide wires from switch/log
to control valve. Place switch/log so the
switch is easy to access.
Flat Front Burner
126817-01D