Table of Contents
Advertisement
Installation Items Needed
• hardware package (provided with appli-
ance)
• approved fl exible gas hose and fi ttings
(provided) (if allowed by local codes)
• sealant (resistant to propane/LP gas, not
provided)
• electric drill with 3/16" masonry drill bit
1. Apply pipe joint sealant lightly to male
threads of the 1/2 NPT side of gas fi tting
elbow (provided) and connect to inlet
side of gas control. Remove gas fi tting
from fl exible gas hose (provided) before
connecting to elbow (see Figure 10).
2. Position appliance base assembly in
fi replace.
3. Mark screw locations through holes in
front panel of base (see Figure 11). If
installing in a brick-bottom fi replace, mark
screw locations in mortar joint of bricks.
4. Remove appliance base from fi replace.
5. Drill holes at marked locations using 3/16"
drill bit.
6. Attach base, through holes in back side pan-
els of base, to fi replace fl oor using masonry
screws provided in hardware package (see
Figure 11).
7. Connect to gas supply. See Connecting
To Gas Supply.
Elbow, 3/8 NPT x
3/8 Flare
Gas Control
Figure 10 - Attaching Flexible Gas Hose
to Appliance Gas Regulator
126817-01D
INSTALLATION
Continued
Flexible Gas Hose
(Install if allowed
by local codes)
SuperiorFireplaces.us.com
Masonry Screw
Figure 11 - Attaching Base to Fireplace
Floor
CONNECTING TO GAS SUPPLY
WARNING: This appliance
requires a 3/8" NPT (National Pipe
Thread) inlet connection to the
pressure regulator.
WARNING: A qualifi ed service
person must connect appliance to
gas supply. Follow all local codes.
CAUTION: Never connect
propane/LP appliance directly
to the propane/LP supply. This
appliance requires an external
regulator (not supplied). Install
the external regulator between the
appliance and propane/LP supply.
WARNING: Never connect
natural gas appliance to private
(non-utility) gas wells. This gas
is commonly known as wellhead
gas.
13
Advertisement
Table of Contents
