Table of Contents
Advertisement
Quick Start Guide - SW MTP T Series, cont'd
Step 6
Tip
See caution
Sleeve
Cable the captive
Tip
See caution
screw audio
Unbalanced Output
output connector
for stereo,
Tip
Ring
balanced or
Sleeve (s)
Tip
unbalanced
Ring
audio output.
Balanced Output
Step 7
Connect an RS-232 OR contact closure
controller. Wire the connector as shown
in the table at right.
Step 8
Connect power cords and turn on the
equipment: output devices (projectors,
monitors, speakers), SW MTP T Series
switcher, contact closure/RS-232
controller, and input devices (computers,
audio sources).
Input selection (normal switch mode)
Select an input using the front panel buttons (as shown below), or the
contact closure or RS-232 controller (switcher must be in normal switch
mode). The selected input's LED lights.
1
2
3
MODE
AUTO
NORMAL
Input selection (auto switch mode)
When the switcher is in auto switch mode, it switches to the highest-
numbered input with a sync signal present. The selected input's LED
lights.
If no input has sync signals present, no input is selected. No input LED
lights.
Switch mode selection
Select the switch mode by pressing and holding the Input 1/Mode button
and pressing and releasing either the Input 2/Normal (normal switch
mode) or Input 3/Auto (auto switch mode) button. Release the
Input 1/Mode button. The Auto Switch LED lights when the switcher is
in auto switch mode.
QS-2
SW MTP T Series Switchers • Quick Start Guide
Connect the sleeve
CAUTION
to ground.
Connecting the
sleeve to a negative
(-) terminal will
damage the audio
output circuits.
REMOTE
Contact
Closure Function
RS-232
Pin
-
In #1
Input #1
1
TX
-
Transmit data
2
3
RX
-
Receive data
-
In #2
Input #2
4
Gnd
Gnd
Ground
5
-
In #3
Input #3
6
-
In #4
Input #4
7
Input #5
8
-
In #5
-
In #6
Input #6
9
4
5
6
Table of Contents
Chapter 1 • Introduction
About the SW MTP T Series Switchers
TP Cable Advantages
Transmission distance ............................................................ 1-3
...................................................................................... 1-4
Chapter 2 • Installation
Mounting the Switcher
Tabletop use ........................................................................... 2-2
Rack mounting ....................................................................... 2-2
Back of the rack mounting ................................................... 2-4
Furniture mounting ............................................................... 2-6
Rear Panel Features and Connections
Power connection .................................................................. 2-7
Signal input connections ....................................................... 2-8
Signal output connection ...................................................... 2-9
Remote connection ............................................................. 2-10
TP Cable Termination
Chapter 3 • Operation
................................................................ 3-1
Front Panel Controls and Indicators
Front Panel Operations
Normal and auto switch mode ............................................. 3-3
Selecting normal switch mode .............................................
Selecting auto switch mode .................................................
Selecting an input in normal switch mode .......................... 3-3
Rear Panel Pre-Peak Switch
Skew Delay Problems
SW MTP T Series Switchers • Table of Contents
.......................................................... 1-1
........................ 1-2
........................................................... 1-3
............................................................ 2-1
...................................................... 2-2
......................... 2-7
......................................................... 2-11
............................ 3-2
....................................................... 3-3
.............................................. 3-4
.......................................................... 3-4
3-3
3-3
i
Advertisement
Table of Contents
