Furniture Mounting; Power Connection - Extron electronics SW2 MTP T 15HD A User Manual

Installation, cont'd

Furniture mounting

For furniture mounting, do not attach the rubber feet. Furniture
mount the switcher using the optional mounting kit
(part #70-212-01) (figure 2-5) as follows:
A U
S W T O
IT C
H
1
2
M O
D E
IN
3 P U
N O T
R M
A L
4
A U
T O
Figure 2-5 — Attaching the furniture mounting
brackets to an SW MTP T
1. Remove the rubber feet if they were previously installed
on the bottom of the switcher.
2. Attach the furniture mounting brackets to the switcher
with the provided machine screws.
3. Hold the switcher with the attached brackets against the
underside of the mounting surface. Mark the location of
the bracket's screw holes on the surface.
4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked locations.
5. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw protrudes.
6. Align the mounting screws with the slots in the brackets
and place the switcher against the surface, with the screws
through the bracket slots.
7. Slide the switcher slightly forward or back, then tighten all
four screws to secure the unit in place.
2-6 SW MTP T Series Switchers • Installation
5
6
S W
6 M
T P
T 1
5 H
D
A
Rear Panel Features and Connections
All connectors are on the rear panel (figure 2-6). Depending on
the model of the switcher, the number of connectors on the rear
panel varies.
The SW2 MTP T and SW4 MTP T switchers have fewer
input connectors but are otherwise identical.
2
INPUT 1 INPUT 3
POWER
12V
0.5A MAX
INPUT 2 INPUT 4
1 3
Figure 2-6 — SW6 MTP T switcher rear panel

Power connection

Power connector— Plug the external 12 VDC power supply into
1
this 2-pole captive screw connector. Figure 2-7 shows how to
wire the connectors.
Smooth
Ridges
A A
Power Supply
Output Cord
Figure 2-7 — Power connector wiring
CAUTION Power supply voltage polarity is critical. Incorrect
voltage polarity can damage the power supply and
the switcher. Identify the power cord negative lead
by the ridges on the side of the cord (figure 2-7).
CAUTION The length of the exposed (stripped) copper wires is
important. The ideal length is 0.2" (5 mm).
Longer bare wires can short together. Shorter wires
are not as secure in the captive screw connectors
and could be pulled out.
SW MTP T Series Switchers • Installation
3 7
REMOTE
INPUT 5
RGB/AUDIO AUDIO
PRE-
PEAK L R
ON
OFF
INPUT 6
OUTPUT
3 5 4 6
SECTION A–A
0.2" (5 mm)
Captive Screw
Connector
2-7