Extron electronics SW2 MTP T 15HD A User Manual page 3

Quick Start Guide — SW MTP T Series
Install and operate the SW MTP T Series switchers as follows:
Step 1
Turn all of the equipment off and disconnect it from the power
source.
Step 2
Mount the switcher in a rack or furniture, or place on a desktop.
Step 3
Connect up to six video input cables,
depending on the switcher model.
Connect up to six audio input cables,
depending on the switcher model.
Step 4
Connect the Twisted Pair (TP) video and audio output cable.
Side Clip Down
Pins 1 2 3 4 5 6 7 8
RJ-45
connector
568 A
Pin Wire color
1 White-green
2 Green
3 White-orange
4 Blue
1 2 3 4 5 6 7 8
5 White-blue
6 Orange
7 White-brown
8 Brown
Twisted
Pairs
NOTE
1&2 7&8
3&6 4&5
Step 5
Connect the other end of the TP cable to an MTP R 15HD A or
MTP RL 15HD A receiver.
SW MTP T Series Switchers • Quick Start Guide
Video Input Audio Input
Connector Connector
1
568 B
Wire color Signal
White-orange Red+/V. sync+
Orange Red–/V. sync–
White-green Mono audio+
Blue Green+
White-blue Green–
Green Mono audio–
White-brown Blue+/H. sync+
Brown Blue–/H. sync–
If you are using Enhanced Skew-Free™
A/V cable, use the TIA/EIA T 568A
standard only.
QS-1