Toshiba RAS-10JKVP-E Service Manual page 77

11-2. How to replace the parts of electric dust collector
(Be sure to pull off the power plug before work.)
No. Part name

Electric dust
collector
‚
Main frame
unit
ƒ
Upper frame
collector
„
High-
pressure unit
Procedures
1) Remove the front panel. (
2) Remove a fixing screw and a connector.
3) Remove the minus ion generator.
4) Remove the electric dust collector vertically to
the heat exchanger.
<Caution at installation>
1) Arrange screw hole on the end plate correctly to
screw hole on the electric dust collector, insert
the fixing hooks at the rear side of the dust collector
into the heat exchanger, and then fix it with a screw.
2) Install the minus
ion generator.
3) Perform wiring of the
lead wire as follows:
1) Follow to the procedure in item
2) Remove the dust collector unit.
(Lift up it once, and then draw out it.)
1) Remove the dust collector unit.
2) Remove the fixing hooks at 6 positions, and
separate the unit into upper frame and collector.
1) Follow to the procedure in item
2) Remove two fixing hooks at upper and lower
sides of the cover to remove the cover.
3) Remove thick red and black Faston lead wires
and the connector attached to the main frame.
4) Remove the earth cover at the rear side of the
electric dust collector, and then remove the thin
black Faston wire.
5) As shown in the right figure, widen outward the
rib at the right side of the main frame and
remove the hooks of the high-pressure unit to
remove the high-pressure unit.
<Caution at installation>
1) Perform cabling as shown in the right figure.

Front panel)

.

.
– 77 –
Remarks
Connector
Pipe
Minus ion generator
Fixing hooks for
heat exchanger
Connector
Pipe
Screw (1 pc.)
Main frame
Hook
Hook
1
2
Dust collector unit
Hooks
Upper frame
Hook
Collector
Hooks
Main frame unit Hook
Hook
Connector
Black
Black
(thin)
Red
Boss for
positioning
Screw
(1 pc.)
Hook
Cover