Toshiba RAS-10JKVP-E Service Manual page 40

8-6-2. Name and Functions of Indications on Remote Controller
[Display]
All indications, except for the clock time indicator, are displayed by pushing the
1
Transmission mark
This transmission mark
remote controller transmits signals to the indoor
unit.
2
Mode display
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover
control, : Cool,
3
Temperature display
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
no temperature setting is indicated.
4
Air purifying indicator
Shows that the electrical air purifying operation is
in progress.
5
FAN speed display
Indicates the selected fan speed. AUTO or five
fan speed levels (LOW
+
MED , MED
shown.
Indicates AUTO when the operating mode is
either AUTO or : Dry.
3 1 4 2 8
AUTOA
HiPOWER
AUTO
CHK
AUTO
9 7
• In the illustraBtion, all indications are indicated for explanation.
During operation, only the relevant indications will be indicated on the remote controller.
indicates when the
: Dry, : Heat)
: Fan only,
, LOW + ,
, HIGH ) can be
10
AM
:
B PM
ON
P
OFF
˚ C
AM
:
PM
5 6
6
TIMER and clock time display
The time setting for timer operation or the clock
time is indicated.
The current time is always indicated except during
TIMER operation.
7
Hi-POWER display
Indicates when the Hi-POWER operation starts.
Push the Hi POWER button to start and push it
again to stop the operation.
8
P (MEMORY) display
Flashes for 3 seconds when the MEMO button is
pushed during operation.
The mark is shown when holding down the
P
button for more than 3 seconds while the mark is
flashing.
Push another button to turn off the mark.
9
ECO indicator
Indicates when the ECO is in activated.
Push the ECO button to start and push it again to
stop operation.
10
A, B change indicator remote controller
Push the CHECK point and MODE button at the
same time to change the remote controller setting
fron "A" to "B". (Priority is given to the "A" setting.)
The E-Parts of the indoor unit are also changed to
the "B" setting.)
– 40 –
button.
A
OFF
:
PM
AUT UTO