Toshiba RAS-10JKVP-E Service Manual page 76

No. Part name
‡
Drift fan • Caution at reassembly
a) At assembling work of the bearing base, check that
b) To incorporate the fan motor, remove the fan motor
c) For incorporation of the motor band (Right), follow
Procedures
the drain pipe is surely incorporated
in the rear plate.
(Otherwise, water
leak is caused.)
rubber (at shaft core side), incorporate the motor
into the position in the following figure, and then
install the fan motor.
• Install the drift fan so that the right end of the 1st
joint from the right of the draft fan is set keeping
70.5mm from wall of rear plate of the main unit.
• Holding the set screw, install the drift fan so that
U-groove of the fan motor comes to the mounting
hole of the set screw.
• Install the fan motor for service work so that the
center D-letter cut part comes to the set screw
mounting hole position.
Center D-letter cut part
• Perform positioning of the fan motor as follows:
Arrange mark of the concave
round hole (or circle mark)
correctly with mark of
the motor band (Right).
Mark
to the above procedure b), incorporate two hanging
hooks of the motor band (Right) into the main unit,
and then follow to the reverse procedure in 7).
Motor band
(Right)
Drain pipe
U groove
Concave round
hole or circle mark
Hanging hooks
(Two positions)
– 76 –
Remarks
Joint
70.5mm