How To Replace The Main Parts - Toshiba RAS-10JKVP-E Service Manual

11-1. Indoor Unit
No. Part name

Front panel
‚
Electric parts
box assembly
ƒ
Horizontal
louver

11. HOW TO REPLACE THE MAIN PARTS

Procedures
1) Stop operation of the air conditioner and turn off
its main power supply.
2) Push "PUSH" part under the front panel and
remove hooks of the front panel from the
installation board.
3) Remove the front panel fixing screws (2 pcs.)
while opening the suction grille.
4) Push the electric parts box with the right thumb
while drawing the both sides of the front panel
toward you.
<How to mount the front panel>
1) Push three center positions and two lower
center positions of the discharge port, and then
hang the hanging hooks (4 cs.) at the top side
of the front panel to the rear plate.
2) Tighten two screws.
• Incomplete hanging or incomplete pushing
may cause a dewdrops or generation of a
beep sound.
1) Follow to the procedure in the above item
2) Remove the drain guide.
3) Remove the electric dust collector. (*)
4) Remove screw attached to the end plate of the
heat exchanger.
5) Remove the lead wire cover, and remove
connector (5P) for the fan motor and connector
(5P) for the louver motor from the microcom-
puter assembly.
6) Remove a fixing screw of the electric parts base
and draw out it toward you.
7) Pull out TC sensor from sensor holder of the
heat exchanger.
8) As shown in the right figure, treat the lead wire
surely after replacement of the parts.
(Otherwise, water leak is caused.)
* For removal/mounting of the electric dust
collector, follow to the item
the electric dust collector.
1) Remove shaft of the horizontal louver from the
rear plate. (First remove the left shaft, and then
remove other shafts while sliding the horizontal
louver leftward.)

.

, How to replace
– 73 –
Remarks
Installation
board
Front panel
Push
Push Push
Hanging hooks at the top side
(4 positions)
Fixing
screw
Push Push
Screw
Drain
guide
Lead wire
cover
TC sensor
Fixing screw
Fixing
screw