Adjusting Anti-Tippers - Invacare Action3 Junior Service Manual

Adjusting Anti-Tippers

NOTE: For this procedure, refer to FIGURE 9.3.
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 30 to 50
mm clearance between the bottom of the anti-tipper wheels and the ground/ floor.
This spacing should always be checked whenever adjustments/changes are made
to the wheelchair.
Make sure that the anti-tipper wheel is ALWAYS located outside the rear wheel
volume.
Failure to maintain proper spacing may result in the chair tipping over backward
causing serious injury or property damage
1. Press the release buttons on the wheeled portion of the anti
down to achieve the 30 to 50 mm clearance.
2. Check to make sure that the release buttons are fully engaged in adjustment holes.
NOTE: Make sure that the anti-tipper wheel is ALWAYS located outside the rear
wheel volume (50 mm Minimum); refer to FIGURE 9.3.
50 mm Mini
Anti-tipper
wheel
W A R N I N G
FIGURE 8.2
30 to 50 mm Adjusting Anti-Tippers
FIGURE 9.3
Adjusting Anti-Tippers
4 5
SECTION 9—ANTI-TIPPERS
tipper and slide it up or
-