Janome Skyline S5 Service Manual page 37

STEP AND
ITEMS TO
CHECk
14)
Attach the needle plate.
NEEDLE
Attach the needle plate for straight
PLATE
stitch.
If the result is correct condition,
press the start/stop button to pro-
ceed the next step.
If the result is defective condition,
press the reverse stitch button to
proceed the next step.
Buzzer sounds after few seconds when the self-diagnostic test has been finished.
The test result has been determined.
The defective part number.
See page 31-35 "Steps and
items" section.
Turn the power switch off when the self-diagnostic test is finished.
TO DISPLAY THE VERSION OF THE PROgRAM
While pressing the needle up/
down and lock stitch buttons, turn
the power switch on.
The LCD screen display "----".
Diagnosis test
PROCEDURE
LCD displays "15".
When the needle plate is attached to
the machine, LCD displays "PSZ".
When the needle plate for straight
stitch is attached to the machine, LCD
displays "PSS".
When nothing is attached to the
machine, LCD displays "15" only.
CORRECT:
Buzzer sounds and LCD displays "00"
DEFECTIVE:
Caution buzzer sounds and LCD displays the defective part
number. Refer to page 31-35 and fix the defective part.
Press "2" on the touch panel.
CORRECT CONDITION
35
DEFECTIVE CONDITION
Buzzer does not sound.
–REMEDY–
Replace the needle plate
sensor.
Replace the printed
circuit board A.
Press the Start/stop
button once to display the
version of the program.